Tolerance - IED

What tolerance format is marked in red in the drawing?

• Unilateral Tolerance

• Bilateral Tolerance

• Limit Dimensions

• Tolerance Dimensions

What tolerance format is marked in red in the drawing?

• Unilateral Tolerance

• Bilateral Tolerance

• Limit Dimensions

• Tolerance Dimensions

What tolerance format is marked in red in the drawing?

• Unilateral Tolerance

• Bilateral Tolerance

• Limit Dimensions

• Tolerance Dimensions

• The bushing diameter must be at least 1.000 inches but can be no more than 1.005 inches.

• The bushing diameter must be greater than 1.000 inches or less than 1.000 inches

• The upper limit dimension is 1.005 inches

• The actual diameter of the hole is 1.000 inches

• The actual diameter is 1.250 inches

• The size of the outer bushing diameter can vary betwen 1.249 inches and 1.255 inches

• The outer bushing diameter can vary by no more than 0.003 inches greater than or less than the specified diameter of 1.252 inches

• The size of the outer bushing diameter can vary between 1.252 and 1.255 inches

• The contour raduis cannot be greater than 15 mm

• All the deviation is less than the specified size of the dimension

• The contour radius cannot be greater than 15 mm

• The contour diameter can vary by at most 0.1 mm

The overall width of a part is specified to be 3.00 with a bilateral tolerance of 0.02 Write the tolerance as you would see on a dimensioned drawing?

• 3.02

  3.00

• 3.02

  2.98

A piece has a dimension of 54mm ± 0.5mm.  What is the maximum acceptable length?

• 54.5 mm

• 53.5 mm

• 54.05 mm

• 53.95 mm

The maximum (upper) limit of a part is 4.01 mm and the minimum (lower) limit is 3.98 mm.  What is the tolerance?

• 0.01 mm
• .015 mm
• .03 mm
• .
  .035 mm

• 0.251

• 0.240

• 0.260

• 0.02