KS-Quiz-15

In what situation would you enter information in the Damoguard damage menu during a Lowe's inspection?

• Damaged front column

• Damaged horizontal 1

• Damaged Damoguard

• Damaged back column

During a Lowe's inspection, you notice that there is missing safety pins throughout the receiving. What part should you order ?

• J-pins

• Hardware kit (3/8 x 4" bolt kits)

• It depends on the beam type and add a comment.

• Order the same type of safety pins that were used elsewhere in the store

In a Lowe's store, is it required to have safety pins on Bolt-on P beams ?

• Yes

• No

• It depends on the department.

• It's not required but we still create a Low-watch issue

Select the pictures where there is rust issues. (Could be more than 1 answer)

• A

• B

• C

• D

During a Lowe's inspection you notice that a system is OOP (Out of plumb). When should you enter data in the "Previous" section of the floor height ?

• You always have to enter the floor height from previous upright.

• Only when you have to reposition your laser level.

• Only for system that has more than 2 assets

• When the system is OOP in both direction (Down-aisle and Cross-aisle)

During a Lowe's reinspection, you encounter a system that was marked as OOP. After observation, the system is still OOP. How should you create the issue?

• Delete previous issue and create a new OOP issue from scratch. Adding a comment saying the issue was reported in previous inspection.

• Report the initial issue as "Unchanged" but also create a new OOP issue.

• Create a new issue and copy information generated in the OOP calculator into a new OOP issue

During a Lowe's inspection you notice a seismic upright but store is not considered in a high seismic zone. Therefore it is not required to have seismic upright. How should you report this issue.

• It's not considered an issue. No need to report it.

• High-replace since it's an inadequate upright.

• Low-Watch since there is no danger. Also report in the note/recommandation of the report when meeting the MOD

• Only report it in the note/recommandation section of the report when meeting the MOD

For Lowe's inspections, is it required for upright under 60in to be anchored ?

• Yes

• No

• It depends on the use of the system.

How many errors can you find in the layout?

• None

• 1

• 2

• 3

• 4

During the inspection of an outside lawn and garden in a Lowe's store, you notice that there is a system that is OOP but there is already an adjustable leg that is set at the highest level and there is also an amount of shims that is greater than 6x the diameter of the anchor. What should you do ?

• Measure the out of plumb of the system using the OOP calculator

• Create an issue on the concrete slab

• Create an issue on the shims

• Create an upright out-of-plumb issue, add comment.

• All of the answers