TIG special Test 2 third year

TIG special Test 2 third year

University

20 Qs

quiz-placeholder

Similar activities

ELECTRONICS

ELECTRONICS

University

20 Qs

TechnoFreak

TechnoFreak

University

20 Qs

FIELD EFFECT TRANSISTOR

FIELD EFFECT TRANSISTOR

University

20 Qs

Basic Electrical Engg. 456

Basic Electrical Engg. 456

University

20 Qs

Earth Faults and Protection Quiz

Earth Faults and Protection Quiz

12th Grade - University

20 Qs

Middle Ear Anatomy

Middle Ear Anatomy

University

18 Qs

SMJE 2083 Electronic Circuits Quiz 1

SMJE 2083 Electronic Circuits Quiz 1

University

15 Qs

AC Fundamentals - III

AC Fundamentals - III

University

22 Qs

TIG special Test 2 third year

TIG special Test 2 third year

Assessment

Quiz

Architecture, Other

University

Hard

Created by

Jayamani K

Used 1+ times

FREE Resource

20 questions

Show all answers

1.

MULTIPLE CHOICE QUESTION

2 mins • 1 pt

The short circuit impedance is given by 18 ohm and the characteristic impedance is 50 ohm. Find the open circuit impedance.
138.8
188.3
388.1
838.1

2.

MULTIPLE CHOICE QUESTION

1 min • 1 pt

For a load impedance of ZL=60-j80. Design of 2 single-stub shunt tuning networks to match this load to a 50Ω line is to be done. What is the normalized admittance?
1+j
0.3+j0.4
0.4+j0.3
0.3-j0.4

3.

MULTIPLE CHOICE QUESTION

1 min • 1 pt

If the normalized admittance at a point on a transmission line to be matched is 1+j1.47. Then the normalized susceptance of the stub used for shunt stub matching is:
1 Ω
1.47 Ω
-1.47 Ω
-1 Ω

4.

MULTIPLE CHOICE QUESTION

1 min • 1 pt

 In series stub matching, if the normalized impedance at a point on the transmission line to be matched is 1+j1.33. Then the reactance of the series stub used for matching is:
1 Ω
 -1.33 Ω
-1 Ω
1.33 Ω

5.

MULTIPLE CHOICE QUESTION

1 min • 1 pt

The characteristic impedance of a line having open and short impedances of 20 and 5 respectively is
20
100
250
10

6.

MULTIPLE CHOICE QUESTION

5 sec • 1 pt

A spectrum of 30 MHz is allocated to a cellular system which uses two 25 KHz simplex channels to provide full duplex voice channels. What is the number of channels available per cell for 4 cell reuse factor?
150 Channels
100 Channels
200 Channels
115 Channels

7.

MULTIPLE CHOICE QUESTION

5 sec • 1 pt

Which among the following processing steps combine multiple OFDM subcarriers into a single signal for transmission?
Serial to Parallel conversion
FFT
IFFT
Channel Mapping

Create a free account and access millions of resources

Create resources
Host any resource
Get auto-graded reports
or continue with
Microsoft
Apple
Others
By signing up, you agree to our Terms of Service & Privacy Policy
Already have an account?