RSE_Chapter8_DHCP

What is DHCP?

• Dynamic Host Control Protocol

• Dynamic Host Configuration Protocol

• Dynamic Hostess Control Protocol

• Dynamic Host Control Port

What purpose does DHCPv4 serve?

• To allow network administrators to manually assign IPv4 addresses and other network configuration information.

• To allow network administrators to dynamically assign IPv4 addresses and other network configuration information.

• It serves no purpose as it's a useless and time-wasting tool for network administrators.

• To allow network administrators to subnet IPv4 addresses in VLSM format to facilitate network design.

Which of the DORA message is sent as a broadcast?

• DHCPDISCOVER

• DHCPOFFER

• DHCPREQUEST

• DHCPACK

Which of the following DORA messages is sent as a unicast?

• DHCPDISCOVER

• DHCPOFFER

• DHCPREQUEST

• DHCPACK

To configure a DHCPv4 server, which of the following is NOT a step in the configuration?

• Exclude addresses from the pool that you defined.

• Set up the DHCP pool name.

• Use the no service dhcp command.

• Define the range of addresses and subnet mask. Use the default-router command for the default gateway.

Which of the following is a Cisco IOS command to ascertain DHCP server statistics?

• show running-config

• show ip dhcp binding

• show ip dhcp server statistics

• show startup-config

If you need to configure a helper address to forward your DORA broadcast, on which interface at R1 should you place the helper address command?

• On all interfaces.

• S0/0/0

• G0/0

• G0/1

In the same diagram, what is the command to configure the helper address to forward the DORA broadcasts?

• ip helper-address 192.168.10.1

• ip helper-address 192.168.10.10

• ip helper-address 192.168.11.5

• ip helper-address 192.168.11.6

Which of the following is NOT considered as an option in DHCPv6

• SLAAC

• Stateless DHCPv6

• Stateful DHCPv6

• State DHCPv6