Occ 22 - Part B

What drawing would be used to show the foundation detail?

• Front elevation
• Location plan
• Site plan.
• Section through.

Which scale is commonly used on a detail drawing?

• 1:5
• 1:100
• 1:250
• 1:2500

Which one of the following could be used to take a measurement from an original drawing?

• Protractor
• Scale rule
• T square
• Set square.

Why must existing gas supplies be located before building work begins?

• To cover them with concrete for protection
• To ensure new pipework can be connected.
• To allow maintenance to be carried out.
• To prevent damage to the services.

Why should site clearance take place?

• To allow materials to be delivered
• To ensure the site is ready for setting out.
• To reduce the cost of removing the topsoil.
• To allow Building Inspectors time to inspect the site.

Which one of the following describes the building line?

• A line from which setting out will be taken, approved by the HSE.
• The centre line of a proposed or existing building
• A gridline used to mark the position of internal walls.
• A line from which setting out will be taken, approved by the Local Authority.

What ratio should be used when setting out a right angled corner?

• 1:2:3
• 3:4:5
• 4:5:6
• 5:6:7

Which one of the following should be used to set out a right angled quoin?

• Storey rod.
• T square.
• Straight edge.
• Builder’s square.

It is important to check the diagonal measurements when setting out to ensure the building is

• level
• plumb
• square
• gauged.

Which one of the following will detail the safe sequence of work?

• Method statement
• Building Regulations.
• Specification
• Drawings.