Jointer Unit Test #2

Front

Boards shorter than_____inches in length should NOT be run on the jointer.

Back

12

Front

Place the board with the curve up (so that the concave side is up) when running the board over the cutterhead. True or False?

Back

false

Front

The depth of cut is adjusted by moving the_____table up or down (but we will not adjust ours).

Back

Infeed

Front

The fence sliding lever is used to ______.

Back

move the fence closer or farther from the front of the jointer

Front

The minimum width (across the face) of a board when using your hands for edge jointing is ____ inches.

Back

4 inches

Front

A________should always be used when operating the jointer with stock smaller than the fence is high.

Back

Push stick and push block

Front

The____table is the higher of the two tables on the jointer.

Back

Outfeed

Front

When finished jointing it is your responsibility to make sure the____is stopped before leaving the machine.

Back

Cutterhead

Front

The stock should be fed into the jointer so the machine is cutting____the grain.

Back

with

Front

The jointer should never be operated with the____ removed

Back

guard