Intro to Auto 9

Front

What is a good practice to do when installing new tires?

Back

Replace the valve stems.

Front

The spindle assembly at the rear of the vehicle shows signs of severe wear. Which could be the cause?

Back

dry wheel bearings

Front

A tire is found to have a nail hole in its sidewall. Which should be done?

Back

Replace the tire.

Front

Which is the most likely tool for a technician to use to find a noise traveling through the suspension system? Options: vibration analyzer, chassis ears, test light, scan tool

Back

vibration analyzer

Front

Where would one most likely find the air suspension system disable switch on a vehicle?

Back

in the trunk

Front

Before working on a hybrid vehicle's electrical power steering system, which personal protective equipment should a technician wear?

Back

insulated gloves rated at 1,000 volts

Front

Which would be the most likely result of adding the wrong steering fluid to a vehicle with rack-and-pinion steering?

Back

seal failure

Front

If a rear wheel spindle is bent, which is the best way to repair the spindle?

Back

Replace it.

Front

Where would one find the tire information placard on a vehicle listing the recommended tire size and pressure for that vehicle? Options: under the hood, on the doorjamb, in the trunk, in the center console

Back

on the doorjamb

Front

A vehicle's red brake warning light stays on whenever the ignition is on and the engine is running. Any of the following could be the cause except: the ABS has a faulty wheel sensor, the brake fluid is low in the reservoir, the parking brake is engaged, the parking brake switch is out of adjustment.

Back

the ABS has a faulty wheel sensor.