Miter Saw

Front

How must the saw blade be held after the cut is finished and before the blade stops rotating?

Back

Hold it in the down position.

Front

What special protection must be observed when using the motorized miter saw outside? Options: Keep the saw covered., Lubricate the saw more often than normal., Unplug the saw after each cut., Connect the saw to a ground fault circuit interrupter (GFCI).

Back

Connect the saw to a ground fault circuit interrupter (GFCI).

Front

How can the saw operator prevent the blade from binding when cutting warped, bowed, or long stock?

Back

Clamp the stock to the table.

Front

When is it safe to remove wood scraps from the cutting zone on the motorized miter saw? Options: While the saw is positioned over material and ready for a cut to be made., While the saw blade is clamped in the down position., While the saw is off and the hand is not on the Off/On switch., While the blade is up.

Back

While the saw is off and the hand is not on the Off/On switch.

Front

Where should the saw blade be positioned when cutting is completed and the operator is leaving the work zone?

Back

Down

Front

Hands or fingers never come closer than __________ to the rotating blade when operating the motorized miter saw.

Back

4 inches

Front

What personal protection equipment should be worn by a motorized miter saw operator? Hearing protection, eye protection and a dust mask, Eye protection, Eye protection and hearing protection, Hearing and eye protection, dust mask and gloves

Back

Eye protection

Front

The purpose of a trial cut before making the actual cut with the motorized miter saw is to____________ .

Back

see if the saw is cutting properly and is set accurately.

Front

Where should the saw blade be aligned when making a cut with the motorized miter saw? Options: Left side of the marking line, Right side of the marking line, Waste side of the marking line, On the marking line

Back

Waste side of the marking line

Front

How should the saw blade be moved throughout the stock when making a cut with a motorized miter saw that has a sliding arm?

Back

Pull out, push down, then push forward